RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Pedal Positioning Motor: Service and Repair
MOTOR - ADJUSTABLE PEDALS
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the kneeblocker.
3. Remove the brake light switch and discard.
4. Disconnect the adjustable pedal cables from the brake and accelerator pedals Also clutch pedal if equipped with a manual transmission.
5. Disconnect the electrical connector.
6. Unclip the cable fasteners to the support.
7. Remove the one mounting bolt (2) for the adjustable pedal motor (1).
8. Remove the adjustable pedal motor (1) with the cables.
NOTE: Adjustable pedal cables are not serviceable. If they need service the adjustable pedal motor with the cables must be installed.
INSTALLATION
NOTE: Adjustable pedal cables are not serviceable. If they need service the adjustable pedal motor with the cables must be installed.
1. Install the adjustable pedal motor (1) with the cables.
2. Install the one mounting bolt (2) for the adjustable pedal motor (1).
3. Clip the cable fasteners to the support.
4. Reconnect the electrical connector.
5. Reconnect the adjustable pedal cables to the brake and accelerator pedals Also clutch pedal if equipped with a manual transmission.
6. Install the new brake light switch.
7. Install the kneeblocker.
8. Reconnect the negative battery cable.
9. Check for proper operation of the pedals.