RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Brake Hose/Line: Service and Repair
Rear Brake Hose
REAR BRAKE HOSE
REMOVAL
1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic
brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the
area of repair instead of the entire system.
2. Raise and support the vehicle.
3. Remove the brake line (3) from the hose (1) at the frame.
4. Remove the brake hose clip (2) at the top of the hose located at the frame.
5. Remove the vent hose (2).
6. Remove the two brake lines (3) at the bottom of the hose (1) located at the axle.
7. Remove the mounting bolt for the brake hose at the axle.
8. Remove the hose.
INSTALLATION
