RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
1. Align the base of the backup (1), park/brake/side marker (2), or park/turn (3) lamp bulb with the appropriate socket in the socket plate (5).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Be certain that a rubber sealing washer (4) is properly installed and in good condition around the base of each bulb on the socket plate.
4. Align the socket plate (2) and bulbs with the openings on the back of the rear lamp unit housing (1).
5. Insert the socket plate and bulbs straight into the housing until the plate is firmly seated.
6. Install and tighten the four screws (3) that secure the socket plate to the housing. Tighten the screws to 1 N.m (12 in.lbs.).
7. Reinstall the rear lamp unit onto the end of the quarter panel.
8. Reconnect the battery negative cable.
