RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Power Distribution Module: Service and Repair
Integrated Power Module
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove cove (4) by loosening the cover screw (1).
3. Remove the B+ terminal nut from the Integrated Power Module (IPM) B+ terminal. Remove the B+ cable from the IPM.
4. Disconnect the gray connector from the IPM.
5. Remove the IPM retaining bolt (2) and screw (3).
6. Grasp the IPM with two hands and slide the assembly in the direction shown to free the module from its mounting bracket. Position the assembly
upside down to access the electrical connectors located on the bottom of the unit.
7. Disconnect the electrical connectors by depressing the locking tab and rotating the connector arm out-board, until the connector is free from the
IPM assembly. Be certain to pull the connectors straight off.
8. Remove the IPM from the vehicle.
INSTALLATION
