RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
3. (G26) KEY-IN IGNITION SWITCH SENSE WIRE SHORT TO GROUND
Turn ignition off.
Disconnect the Ignition Switch connector.
Disconnect the Cluster C3 connector.
Measure the resistance of the (G26) Key-in Ignition Switch Sense circuit to ground at the Ignition Switch connector.
Q: Is the resistance below 100.0 ohms?
YES: Repair the (G26) Key-In Ignition Switch Sense wire for a short to ground. Perform BODY VERIFICATION TEST - VER 1. See: Testing
and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Replace and program the Cluster. Perform BODY VERIFICATION TEST - VER 1. See: Testing and Inspection/Diagnostic Trouble Code
Tests and Associated Procedures/Verification Tests/Body Verification Test
Chime Warning System
