RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Q: Is the resistance below 5.0 ohms?
YES: Replace and program the Instrument Cluster. Perform BODY VERIFICATION TEST - VER 1. See: Computers and Control
Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Repair the (G26) Key-In Ignition Switch Sense circuit for an open. Perform BODY VERIFICATION TEST - VER 1. See: Computers and
Control Systems/Testing and Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
Vehicle Speed Warning Chime Problem
VEHICLE SPEED WARNING CHIME PROBLEM
POSSIBLE CAUSES
-
Incorrect country code programmed in cluster
-
Cluster
Diagnostic Test
1. WITH THE DRBIII CHECK THE COUNTRY CODE SETTING
NOTE: The high speed warning chime is for Gulf Coast Countries only.
Turn the ignition on.
With the DRBIII(R) in Miscellaneous check the Cluster country code setting.
Q: Is the country code incorrect?
YES: Program the correct country code. Perform BODY VERIFICATION TEST - VER 1. See: Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
NO: Replace and program the Cluster. Perform BODY VERIFICATION TEST - VER 1. See: Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Body Verification Test
A/C Heater Control Illumination Inoperative
A/C HEATER CONTROL ILLUMINATION INOPERATIVE