RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
10. Align the tilt steering column knob (2) with the tilt adjuster lever (1) on the left side of the steering column and use hand pressure to snap it back
into place.
11. Reinstall the steering column opening cover onto the instrument panel.
12. If a new clockspring has been installed, remove the plastic locking pin that is securing the clock-spring rotor to the clockspring case to maintain
clockspring centering.
NOTE: When reinstalling the steering wheel, be certain to index the yellow rubber booted engagement dowel on the upper surface of the
clock-spring rotor between the two fins cast into the lower surface of the steering wheel armature hub.
13. Reinstall the steering wheel onto the steering column.
14. Reconnect the steering wheel wire harness connectors to the upper clockspring connector receptacles. Be certain that the steering wheel wire
harness is routed between the steering wheel back trim cover and the steering wheel armature.
15. Reinstall the driver airbag onto the steering wheel.
16. Reconnect the battery negative cable.
