RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
INSTALLATION
1. Position the rear outboard seat belt and retractor (11) to the retractor mounting hole in the lower inner C-pillar (1).
2. Engage the hook on the upper retractor bracket into the slot in the lower inner C-pillar above the retractor mounting hole.
3. Install and tighten the screw (10) that secures the lower retractor bracket to the lower inner C-pillar below the retractor mounting hole. Tighten the
screw to 40 N.m (29 ft.lbs.).
4. Position the seat belt web guide (12) to the inner C-pillar near the belt line.
5. Install and tighten the screw (7) that secures the seat belt web guide to the inner C-pillar. Tighten the screw to 2 N.m (20 in.lbs.).
6. Reinstall the upper and lower trim (2) onto the inner C-pillar.
7. Position the seat belt turning loop (3) onto the upper inner C-pillar.
8. Install and tighten the screw (4) that secures the seat belt turning loop to the C-pillar. Tighten the screw to 40 N.m (29 ft.lbs.).
9. Engage the lower snap features of the new trim cover (5) over the rear outboard seat belt turning loop and, using hand pressure, press firmly and
evenly on the top of the trim cover until it snaps into place.
10. Position the lower seat belt anchor (8) to the base of the inner C-pillar.
11. Install and tighten the screw (9) that secures the lower seat belt anchor to the base of the inner C-pillar. Tighten the screw to 40 N.m (29 ft.lbs.).
12. Reinstall the rear seat into the vehicle.
