RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Center Link: Service and Repair
DRAG LINK
REMOVAL
1. Remove the drag link nut (2) from the pitman arm side (1).
2. Remove the drag link nut from the knuckle side.
3. Remove the drag link (2) from the right knuckle and pitman arm (1) with Puller C-3894A (3).
INSTALLATION
1. Install the drag link (2) to the pitman arm (1). Install the nut and tighten to 88 Nm (65 ft. lbs.).
2. Install the drag link to the right steering knuckle. Install the nut and tighten to 54 Nm (40 ft. lbs.) Then an additional 90°.
3. Install tie rod to the left steering knuckle and drag link. Install the nuts and tighten to 54 Nm (40 ft. lbs.) Then an additional 90°.
4. Remove the supports and lower the vehicle to the surface. Center steering wheel and adjust toe.
5. After adjustment tighten tie rod adjustment sleeve clamp bolts to 61 Nm (45 ft. lbs.).
NOTE: Position the clamp on the sleeve so retaining bolt is located on the bottom side of the sleeve.
