RAM 2500 Truck 4WD V8-5.7L VIN D (2005)
Differential Cover: Service and Repair
COVER-DIFFERENTIAL
REMOVAL
1. With vehicle in neutral, position vehicle on hoist.
2. Remove drain plug.
3. Remove cover bolts.
4. Remove cover and drain lubricant.
INSTALLATION
1. Apply a 6.35mm (1/4 inch) bead of Mopar Silicone Rubber Sealant (1) or equivalent to the cover (2).
CAUTION: If housing cover is not installed within 3 to 5 minutes, the cover must be cleaned and new RTV applied. Failure to follow these
instructions will result in a leak.
2. Install cover and identification tag. Tighten cover bolts in a criss-cross pattern to 41 Nm (30 ft. lbs.).
3. Fill differential to specifications.
4. Install fill plug.