RAM 2500 Truck 4WD V8-5.9L VIN Z (1997)
Fig. 13 Removing Pull Tab
6. Raise the pull tab until it separates from the quick-connect fitting. Discard the old pull tab.
7. Disconnect the quick-connect fitting from the fuel system component being serviced.
8. Inspect the quick-connect fitting body and fuel system component for damage. Replace as necessary.
9. Prior to connecting the quick-connect fitting to component being serviced, check condition of fitting and component. Clean the parts with a
lint-free cloth. Lubricate them with clean engine oil.
10. Insert the quick-connect fitting into the fuel tube or fuel system component until the built-on stop on the fuel tube or component rests against back
of fitting.
11. Obtain a new pull tab. Push the new tab down until it locks into place in the quick-connect fitting.
12. Verify a locked condition by firmly pulling on fuel tube and fitting (15-30 lbs.).
13. Connect negative cable to battery.
14. Start engine and check for leaks.