RAM 2500 Truck 4WD V8-5.9L VIN Z (1997)
Output Yoke/Flange: Service and Repair
REMOVAL
1. Raise and support vehicle.
2. Remove rear propeller shaft.
3. Using a suitable pry tool or slide-hammer mounted screw, remove the extension housing seal.
4. Using Remover 8165, or equivalent, remove bushing from extension housing.
INSTALLATION
1. Clean fluid residue from sealing surface and inspect for defects.
2. Position replacement bushing in extension housing with fluid port in bushing aligned with slot in housing.
3. Using Installer 8166, or equivalent, drive bushing into housing until installer seats against case.
4. Using Installer 8154, or equivalent, install seal in extension housing.
5. Install propeller shaft.
6. Verify proper fluid level.
7. Lower vehicle.