RAM 2500 Truck 4WD V8-5.9L VIN Z LDC (1998)
Load Compensator: Service and Repair
REMOVAL
1. Raise and support vehicle.
Valve Link
2. Remove the link from the bracket.
Height Sensing Proportioning Valve
3. Remove the link from the actuator lever.
4. Remove brake line and hose from the valve.
5. Remove the two nuts from the frame mounting bracket and remove the valve assembly.
INSTALLATION
1. Install the valve assembly on the frame rail and tighten the mounting nut to 34 Nm (25 ft.lbs.).
2. Install the brake line to the valve and tighten to 19 Nm (170 in.lbs.).
3. Install the brake hose to the valve and tighten the bolt to 31 Nm (276 in.lbs.).
4. Install the link to the actuator lever and bracket.
5. Bleed rear brakes.
6. Remove support and lower the vehicle.