dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 7768 > < Diagram Information and Instructions|Page 7766
Page 1
background image

Cigarette Lighter: Testing and Inspection

WARNING:  ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY
.

1. Check the fuse in the junction block. If OK, go to Step 2. If not OK, repair the shorted circuit or component as required and replace the faulty fuse.
2. Turn the ignition switch to the On position. Check for battery voltage at the fuse in the junction block. If OK, go to Step 3. If not OK, repair the

open circuit to the ignition switch as required.

3. Turn the ignition switch to the Off position. Remove the cigar lighter knob and element from the cigar lighter receptacle. Check for continuity

between the inside circumference of the cigar lighter receptacle and a good ground. There should be continuity. If OK, go to Step 4. If not OK, go
to Step 5.

4. Turn the ignition switch to the On position. Check for battery voltage at the insulated contact located at the back of the cigar lighter receptacle. If

OK, replace the faulty cigar lighter knob and element. If not OK, go to Step 5.

5. Turn the ignition switch to the Off position. Disconnect and isolate the battery negative cable. Remove the cigar lighter receptacle from the

instrument panel and unplug the wire harness connector. Check for continuity between the ground circuit cavity of the cigar lighter wire harness
connector and a good ground. There should be continuity. If OK, go to Step 6. If not OK, repair the open circuit to ground as required.

6. Connect the battery negative cable. Turn the ignition switch to the On position. Check for battery voltage at the fused ignition switch output

(run/accessory) circuit cavity of the cigar lighter wire harness connector. If OK, replace the faulty cigar lighter receptacle. If not OK, repair the
open circuit to the junction block fuse as required.

Diagram Information and Instructions|Page 7768 > < Diagram Information and Instructions|Page 7766