RAM 2500 Truck 4WD V8-5.9L VIN Z LDC (1998)
Crankshaft Position Sensor: Service and Repair
REMOVAL
The sensor is bolted to the top of the cylinder block near the rear of right cylinder head.
1. Remove the air cleaner intake tube.
2. Disconnect crankshaft position sensor pigtail harness from main wiring harness.
Crankshaft Position Sensor
3. Remove two sensor (recessed hex head) mounting bolts.
4. Remove sensor from engine.
INSTALLATION
1. Position crankshaft position sensor to engine.
2. Install mounting bolts and tighten to 8 N.m (70 in. lbs.) torque.
3. Connect main harness electrical connector to sensor.
4. Install air cleaner tube.
