RAM 2500 Truck 4WD V8-5.9L VIN Z LDC (1998)
8. Remove cable housing at throttle body mounting bracket by pressing on release tab with a small screwdriver.
-
To prevent cable housing breakage, press on the tab only enough to release the cable from the bracket.
-
Lift the cable housing straight up from bracket while pressing on release tab.
-
Remove throttle cable from vehicle.
INSTALLATION
1. Rotate and hold the throttle cam in the full wide open position. Snap the cable end onto lever pin.
2. Connect cable to throttle body mounting bracket (push down and lock).
3. Connect cable to fan shroud routing clip.
4. Install the remaining cable housing end into and through the dash panel opening (snaps into position). The two plastic pinch tabs should lock the
cable to dash panel.
5. From inside the vehicle, hold up the accelerator pedal.
-
Install the throttle cable core wire and plastic cable retainer into and through the upper end of the pedal arm (the plastic retainer is snapped into
the pedal arm).
-
When installing the plastic retainer to the accelerator pedal arm, note the index tab on the pedal arm.
-
Align the index slot on the plastic cable retainer to this index tab.
