RAM 2500 Truck 4WD V8-5.9L VIN Z LDC (1998)
Pinion Gear: Service and Repair
Front
NOTE: The ring and pinion gears are serviced in a matched set. Do not replace the pinion gear without replacing the ring gear.
REMOVAL
1. Remove differential assembly from axle housing.
2. Mark the pinion yoke and propeller shaft for installation alignment.
3. Disconnect propeller shaft from pinion yoke. Using suitable wire, tie propeller shaft to underbody.
4. Using Yoke Holder 6719 to hold yoke, remove the pinion yoke nut and washer.
Pinion Yoke Removal
5. Using Remover C-452 and Wrench C-3281, remove the pinion yoke from the pinion shaft.
Remove Pinion Gear
6. Remove the pinion gear from housing. Catch the pinion with your hand to prevent it from falling and being damaged.
7. Remove the pinion gear seal with a slide hammer or suitable pry bar.
8. Remove oil slinger, if equipped, and the front pinion bearing.