RAM 2500 Truck 4WD V8-5.9L VIN Z LDC (1998)
12.
Secure the latch with the new screws that came with package p/n 04773094 and tighten the screws to 1.5 N.m (15 in. lbs.).
13.
Position the new keeper (from package p/n 04773094) onto the new left side glass panel, p/n 05012943AA.
14.
Secure the keeper with the new screws that came with package p/n 04773094 and tighten the screws to 1.5 N.m (15 in. lbs.).
15.
Liberally apply weatherstrip lubricant, p/n 04773427, to the seal on the left hand side rear window glass.
16.
Apply a 0.5 mm bead of pumpable type butyl such as 3M Windo-Weld (3M p/n 08633) to the bond area on the new rear sliding window lower run
channel (p/n 05011532AA) (Figure 3).
CAUTION:
IT IS CRITICAL THAT THE BUTYL BEAD IS NOT EXCESSIVE. EXCESSIVE BUTYL CAN CAUSE A HYDROSTATIC LOCK,
PREVENTING THE LOWER RUN WINDOW CHANNEL FROM BEING PROPERLY INSTALLED.
17.
Position the left and right glass panels into the lower run channel.
18.
Position the glass into the upper run channel. Then, snap the lower window run channel assembly into the lower rail.
NOTE:
AGGRESSIVE CLAMP PRESSURE IS REQUIRED TO LOCK LOWER RUN CHANNEL INTO PLACE.
19.
Once assembled, fill the ends of the run channel with Mopar GEN II Silicone Rubber Adhesive Sealant, p/n 04883971.
20.
Remove protective tape and clean the window.
21.
On Quad Cab and Club Cab vehicles, position the rear seat into the vehicle.
22.
Align seatback hooks with the loops on the cab rear panel (Figure 2).
23.
Align the side support alignment tabs, and lower seat into place (Figure 1).
24.
Install side support bracket bolts and tighten the bolts.
25.
Turn the release handle to disengage seat from stowed position and push seat cushion downward to lock into place.
Procedure C
1.
Pry open the slide glass.
CAUTION:
BE CAREFUL NOT TO SCRATCH THE FRAME.
2.
Liberally apply weatherstrip lubricant, p/n 04773427, to the seal on the left hand side rear window glass.
3.
Open and close the slide glass to ensure freedom of movement.