RAM 2500 Truck 4WD V8-5.9L VIN Z LDC (1998)
2.
Remove latch and keeper screws.
3.
Separate latch and keeper from glass panel.
4.
Position new latch and keeper (from package p/n 04773094) onto the glass panels.
5.
Secure the latch and keeper with the new screws that came with package p/n 04773094 and tighten the screws to 1.5 N.m (15 in. lbs.).
Procedure B
1.
Move front seat track to full forward position.
2.
On Quad Cab and Club Cab vehicles, turn the release handle on underside of rear seat to disengage seat cushion and move seat to the stowed
position (Figure 1).
3.
Remove the rear seat side support bracket bolts and lift the seat up to disengage it from the cab (Figure 2).
4.
On standard cab vehicles, apply protective tape to the trim directly below the rear sliding glass window.
5.
Remove the run channel by rolling the channel into the cab at both ends and then, pulling it out from one end.
6.
Remove the sliding glass from the rear window module assembly.
7.
Remove any excess sealer from the lower run channel area of the rear window module assembly.
8.
Clean the sealer bond area with a Hand Scuff Pad, p/n 04856937.
9.
Clean the bond area with Mopar Tar And Road Oil Remover, p/n 04886330AA.
10.
Clean the bond area with a 50/50 mixture of Isopropyl Alcohol and water.
11.
Position the new latch (from package p/n 04773094) onto the new right side glass panel, p/n 05012942AA.
