RAM 2500 Van V6-239 3.9L Magnum (1995)
e. Rotate the tensioner assembly clockwise (as viewed from front) until tension has been relieved from belt.
f.
Remove belt from generator pulley.
g. Remove the two generator mounting bolts. Do not remove any wiring at generator.
h. Remove generator. Position generator to gain access for thermostat gasket removal.
i.
Remove the three Jeep/Truck Engine Controller (JTEC) mounting bolts and remove JTEC. Do not disconnect 60-way connector from JTEC.
Lay JTEC aside.
WARNING: CONSTANT TENSION HOSE CLAMPS ARE USED ON MOST COOLING SYSTEM HOSES. WHEN REMOVING OR
INSTALLING, USE ONLY TOOLS DESIGNED FOR SERVICING THIS TYPE OF CLAMP, SUCH AS SPECIAL CLAMP TOOL
NUMBER 6094. SNAP-ON CLAMP TOOL NUMBER HPC-20, OR EQUIVALENTS MAY BE USED FOR LARGER CLAMPS. ALWAYS
WEAR SAFETY GLASSES WHEN SERVICING CONSTANT TENSION CLAMPS.
