RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
Speed Control Servo Bracket Remove/Install
6. Remove 2 nuts from servo mounting bracket.
7. Pull servo away from mounting bracket.
8. Remove and discard push nuts on servo studs.
Servo Cable Remove/Install
9. Pull speed control cable away from servo to expose cable retaining clip.
10. Remove clip attaching cable to servo.
11. To install, block throttle to full open position and align hole in cable sleeve with hole in servo pin. Install retaining clip.
12. Reverse remaining removal procedures to install. Tighten servo mounting bracket nuts to 8.5 Nm (75 in lb). Tighten servo mounting bolts to 11
Nm (95 in lb).
