RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
11.
Pre-assemble the supplied AECM and AECM wiring jumper by routing the AECM wiring jumper harness under the new A£CM. Connect the
jumper harness to the mating connector on the AECM and to the two (2) wiring harness connectors that were connected to the old AECM (Figure
4). Make sure that the connector latches are fully engaged and then secure the jumper harness by inserting the harness clips into the AECM bracket
holes (Figure 4).
12.
If there were wires routed over the AECM plastic cover, route these wires in the trough area of the AECM bracket (Figure 4).
13.
Install the AECM and bracket assembly with the jumper harness onto the floor pan mounting bracket. Be sure that the arrow on the AECM is
pointing forward (Figure 4). Care should be taken to prevent pinching of the wires in the trough area.
14.
Install the four provided AECM mounting screws. Tighten the screws to 60 in-lbs (6.8 N.m).
