RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
Heated Glass Element Relay: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
Heater-A/C Control Bezel Remove/Install
2. Remove the screws that secure the heater - A/C control bezel to the instrument panel.
3. Pull the control bezel out from the instrument panel far enough to access the rear of the defogger switch.
Rear Defogger Switch, Relay And Timer Module Remove/Install
4. Squeeze the defogger switch retaining tabs and pull the module out from the rear of the heater - A/C control bezel.
5. Unplug the wire harness connector from the back of the defogger switch and remove the switch from the vehicle.
6. Reverse the removal procedures to install.
