RAM 2500 Van V8-318 5.2L VIN T Magnum CNG SFI (1997)
24. Install direct clutch pack snap ring. Be very sure snap ring is fully seated in clutch drum ring groove.
25. Install clutch hub retaining ring. Be very sure retaining ring is fully seated in sun gear ring groove.
26. Slowly release press ram, remove compressor tools and remove gear-train assembly.
GEAR CASE ASSEMBLY
1. Position park pawl and spring in case and install park pawl shaft. Verify that end of spring with 90° bend is hooked to pawl and straight end of
spring is seated against case.
2. Install pawl shaft retaining bolt. Tighten bolt to 27 Nm (20 ft. lbs.) torque.
3. Install park lock reaction plug. Note that plug has locating pin at rear. Be sure pin is seated in hole in case before installing snap ring.