RAM 2500 Van V8-360 5.9L Magnum (1995)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
Idle Air Control Motor
REMOVAL
1. Remove air cleaner assembly.
2. Disconnect the negative battery terminal.
3. Disconnect the Idle Air Control (IAC) motor wiring connector.
4. Remove the Torx head mounting screws (2), and remove the IAC from throttle body.
INSTALLATION
1. Install new IAC motor.
NOTE: If the pintle measures more than 25 mm (1 in.), it must be retracted by using the IAC exerciser (Tool # 7558). The battery must be
connected for this procedure.
2. Install the Torx head retaining screws, torquing them to 7 Nm (60 in-lbs).
3. Connect the IAC motor electrical connector.
4. Connect the negative battery cable.
5. Install the air cleaner assembly.
