RAM 2500 Van V8-360 5.9L Magnum (1995)
Exploded View Of Single Cardan Type Universal Joint System
DISASSEMBLE
1. Remove snap rings (or retainer plates) that retain bearings in yoke and driveshaft.
2. Place U-joint in a vise. Do not clamp sliding yoke or driveshaft tube in vise. Clamp only forged portion of sliding yoke or driveshaft yoke.
To avoid yoke distortion, do not over tighten.
3. Select a wrench socket with an outside diameter slightly smaller than the U-joint bearings. Select another wrench socket with an inside diameter
slightly larger than the U-joint bearings.
4. Place the sockets at opposite bearings in the yoke so that the smaller socket becomes a bearing pusher and the larger socket becomes a bearing
receiver when the vise jaws come together. Close vise jaws until both bearings are free of yoke and remove bearings from the cross or spider.
5. If bearings will not come all the way out, close vise until bearing in receiver socket protrudes from yoke as much as possible without using
excessive force. Then remove from vise and place that portion of bearing which protrudes from yoke between vise jaws. Tighten vise to hold
bearing and drive yoke off with a soft hammer.
6. To remove opposite bearing from yoke, replace in vise with pusher socket on exposed cross journal with receiver socket over bearing cup. Then
tighten vise jaws to press bearing back through yoke into receiving socket.
7. Remove yoke from driveshaft and again place protruding portion of bearing between vise jaws. Then tighten vise to hold bearing while driving
yoke off bearing with soft hammer.
8. Turn spider or cross 1/4 turn and use the same procedure to press bearings out of driveshaft.
ASSEMBLE
1. If old parts are to be reassembled, pack bearing cups with universal joint grease. Do not fill cups completely or use excessive amounts as over
lubrication may damage seals during reassembly. Use new seals.
2. If new parts are being installed, check new bearings for adequate grease before assembling.
3. With the pusher (smaller) socket, press one bearing part way into driveshaft. Position spider into the partially installed bearing. Place second
bearing into driveshaft. Fasten driveshaft in vise so that bearings are in contact with faces of vise jaws. Some spiders are provided with locating
lugs which must face toward driveshaft when installed.
4. Press bearings all the way into position and install snap rings or retainer plates.
5. Install bearings in yoke in same manner. When installation is completed, check U-joint for binding or roughness. If free movement is impeded,
