RAM 2500 Van V8-5.2L CNG VIN T (1999)
Electronic Brake Control Module: Service and Repair
With Rear Wheel Antilock System
NOTE: If the Controller Antilock Brake (CAB) needs to be replaced, the rear axle type and tire revolutions per mile must be programmed into the
new CAB.
REMOVAL
Washer Reservoir & Power Distribution Center
1. Remove the washer reservoir mounting screws.
2. Lift up the reservoir and disconnect the pump motor connector and pump hose.
3. Remove the reservoir from the engine compartment.
4. Disconnect battery cables and remove the battery.
5. Remove the power distribution center.
6. Remove the battery and power distribution center mount.
7. Remove the RWAL valve harness.
CAB Harness Connector
8. Pull up on the CAB harness connector lock release and remove the connector from the controller.
9. Remove controller mounting screws and remove controller.
INSTALLATION
1. Position the controller on the mounting bracket and install the mounting screws.
2. Install the CAB harness connector into the controller and push down on the connector lock.
3. Install the RWAL valve harness connector into controller.