RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
15.
Position the front latch cover onto the inner door panel with the knob latch rod and the outside handle shaft inserted in the cover holes.
16.
Install the cover screws in the door panel.
17.
Position the inside door handle spacers and the inside handle onto the outside handle shaft. Verify both spacers are installed.
18.
Attach the inside handle with the screw.
19.
Install lock knob.
20.
Position the door trim panel on the door inner panel and press inward around the edge of the panel.
21.
Position the door pull handle onto the trim panel with the screw holes aligned.
22.
Install the pull handle screws.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE: P8- New Part
Technical Service Bulletin # 23-15-00
Date: 000421
Sliding Door - Will Not Open And/Or Close/Latch
NUMBER: 23-15-00
GROUP: Body
DATE: April 21, 2000
SUBJECT:
Sliding Door Will Not Open And/Or Close/Latch
MODELS:
1998 - 2000 (AB) Ram Van/Wagon
OVERVIEW:
This bulletin involves installing revised sliding door rear latch assembly and latch rods and modifying the rear latch opening.
NOTE: THIS BULLETIN APPLIES TO VEHICLES EQUIPPED WITH THE SLIDING SIDE DOOR (SALES CODE GKF) BUILT BEFORE
FEBRUARY 26,2000 (MDH 0226XX).
SYMPTOM/CONDITION:
The sliding door will not open and/or will not close/latch.
DIAGNOSIS:
DOOR WILL NOT OPEN
1.
Remove the sliding door trim panel attaching screws.
