RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Rear Door Weatherstrip: Service and Repair
Rear Cargo Door Weatherstrip
REAR CARGO DOOR WEATHERSTRIP
REMOVAL
Fig. 6
NOTE: The door weatherstrip seal (Fig. 6) is attached to the door inner panel with adhesive.
1. Open the cargo door.
2. Start at the lower ends and pull outward on the seal. Separate the seal from the door inner panel.
3. Remove the seal from the door inner panel.
4. Remove the residual adhesive from the door inner panel.
INSTALLATION
NOTE: The door weatherstrip seal (Fig. 6) is attached to the door inner panel with adhesive.
1. Apply adhesive around the edge of the door inner panel.
2. Position the weatherstrip seal on the door.
3. Start at the upper corner of the door. Move downward around the perimeter of the door and press the seal against the door inner panel.
NOTE: The seal must be seated at each corner. Avoid stretching the seal at the corners.
4. When correctly installed, the seal ends will meet exactly at the door lower centerline.
5. Inspect the door fit. If not correct, adjust the door so that the seal is not crushed when the door is closed.
