RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
9. Remove screws attaching CAB to the HCU.
10. Remove the CAB.
INSTALLATION
1. Place the CAB onto the HCU.
NOTE: Insure the CAB seal is in position before installation.
2. Install the mounting screws and tighten to 4.4 Nm (39 inch lbs.).
3. Connect the pump motor harness.
4. Connect the harnesses to the CAB and lock the connectors.
5. Install the reservoir in the engine compartment. Connect the pump motor connector and pump hose.
6. Install the washer reservoir mounting screws.
7. Install the battery and power distribution center mount.
8. Install the power distribution center.
9. Install the battery and battery cables.
