RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Cruise Control Servo: Service and Repair
Speed Control Servo Location
The speed control servo is bolted to the radiator/grille support under the right headlamp.
REMOVAL
1. Disconnect negative battery cable at battery.
2. Remove engine cover.
3. Remove air cleaner housing.
4. Disconnect servo cable at throttle body.
5. Remove right headlamp assembly.
6. Disconnect vacuum hose (line) at servo.
7. Disconnect electrical connector at servo.
8. Remove 2 servo mounting bracket bolts.
Servo Cable Clip Remove/Install - Typical
9. Remove 2 mounting nuts holding servo cable sleeve to bracket.
10. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.
