RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Fig. 30
(5) Remove nuts from brackets and insulators (Fig. 29) (Fig. 30).
(6) Raise engine with support fixture only far enough to remove insulators.
INSTALLATION
(1) If removed, install the engine mounting bracket to the cylinder block. Tighten the bolts to 88 Nm (65 ft. lbs.) torque.
(2) With engine raised SLIGHTLY, install insulators.
(3) Lower engine with support fixture while guiding insulator studs into attaching holes in crossmember and brackets.
(4) Tighten the attaching nuts to 102 Nm (75 ft. lbs.) torque (Fig. 29) (Fig. 30).
(5) Lower the vehicle.
(6) Remove engine support fixture.
