RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
2. Install the four screws that secure the distribution duct to the right side of the dash panel. Tighten the mounting screws to 2.7 Nm (24 in. lbs.).
3. Install the one screw that secures the left floor outlet of the distribution duct to the instrument panel support on the left side of the dash panel
engine housing extension, and the one screw that secures the distribution duct to the dash panel between the two defroster outlets. Tighten the
mounting screws to 4.5 Nm (40 in. lbs.).
4. Position and route the vacuum harness over the distribution duct.
5. Install the one screw that secures the vacuum harness retaining strap near the left end of the distribution duct. Tighten the mounting screw to 2.2
Nm (20 in. lbs.).
6. Plug in the two vacuum harness connections to each of the two vacuum actuators on the upper half of the distribution duct.
7. Reinstall the blend-air door motor to the distribution duct.
8. Reinstall the instrument panel to the vehicle. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair,
Instrument Panel Assembly Replacement, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Assembly
9. Connect the battery negative cable.
