RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
5. Remove the compressor tool, adapter, and the shaft lock shield from the steering column.
6. Remove the turn signal cancel cam from the upper steering column shaft.
INSTALLATION
1. Coat the conductive disc on the lower surface of the turn signal cancel cam evenly with the synthetic grease included in the replacement part
package.
2. Position the turn signal cancel cam onto the upper steering column shaft.
3. Position the shaft lock shield onto the upper steering column shaft. Be certain to index the alignment splines in the hub of the shaft lock shield with
the splines on the upper steering column shaft.
4. Install a new shaft lock shield retaining ring onto the center mandrel of the compressor tool (Special Tool C-4156).
5. Install a compressor adapter (Special Tool 7100) and a compressor tool (Special Tool C-4156) onto the steering column upper shaft.
6. Compress the shaft lock shield far enough to slide the retaining ring off of the mandrel of the compressor tool and into the groove in the upper
steering column shaft.
7. Install the clockspring onto the steering column upper shaft. Be certain that the steering column wire harnesses are routed so that they will not be
pinched or stretched,
8. Reconnect the battery negative cable.
