dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

ABOUT US
Manifold Absolute Pressure (MAP) Sensor <--> [Manifold Pressure/Vacuum Sensor] > < Intake Air Temperature (IAT) Sensor <--> [Intake Air Temperature Sensor]|Specifications|Page 2867

RAM 2500 Van V8-5.2L Prop VIN 2 (2000)

Page 1
background image

Intake Air Temperature (IAT) Sensor: Service and Repair

Fig.28 IAT Sensor Location (Typical)

The Intake Manifold Air Temperature (IAT) sensor is located in the front/side of intake manifold. If equipped with a this engine, removal/installation
may be done from front of vehicle without removal of engine cover or air cleaner housing. 

REMOVAL

1. Disconnect negative battery cable at battery.
3. Disconnect electrical connector at sensor.
3. Remove sensor from intake manifold.

INSTALLATION

1. Install sensor to intake manifold. Tighten to 28 Nm (20 ft. lbs.) torque.
2. Install electrical connector.
3. Connect negative battery cable to battery.

Manifold Absolute Pressure (MAP) Sensor <--> [Manifold Pressure/Vacuum Sensor] > < Intake Air Temperature (IAT) Sensor <--> [Intake Air Temperature Sensor]|Specifications|Page 2867