RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Oxygen Sensor: Service and Repair
Fig.25 Oxygen Sensor Location
The O2S sensors are located at inlet and outlet ends of catalytic converter.
REMOVAL
Never apply any type of grease to the oxygen sensor electrical connector, or attempt any soldering of the sensor wiring harness. For sensor operation,
it must have a comparison source of oxygen from outside the exhaust system. This fresh air is supplied to the sensor through its pigtail wiring harness.
WARNING: THE EXHAUST MANIFOLD, EXHAUST PIPES AND CATALYTIC CONVERTER BECOME VERY HOT DURING
ENGINE OPERATION. ALLOW ENGINE TO COOL BEFORE REMOVING OXYGEN SENSOR.
1. Raise and support vehicle.
2. Disconnect wire connector from O2S sensor.
CAUTION: When disconnecting sensor electrical connector, do not pull directly on wire going into sensor.
3. Remove O2S sensor using an oxygen sensor removal/installation tool.
INSTALLATION
Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to
the threads of a new oxygen sensor.
1. Install 02S sensor. Tighten to 30 Nm (22 ft. lbs.) torque.
2. Connect 02S sensor wire connector.
3. Lower vehicle.
