RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Blower Motor Relay: Service and Repair
High Speed Blower Motor Relay Replacement
Front
REM0VAL AND INSTALLATION
1. Disconnect and isolate the battery negative cable.
Front High Speed Blower Motor Relay Remove/Install
2. The high speed blower motor relay is retained by a snap fit to the blade of the mounting bracket on the inboard side of the heater-A/C housing.
Unsnap the relay from the mounting bracket by sliding it downwards.
3. Unplug the wire harness connector from the high speed blower motor relay.
4. Install the high speed blower motor relay by aligning the relay terminals with the cavities in the relay wire harness connector and pushing the relay
firmly into place.
5. Slide the molded receptacle on the high speed blower motor relay case back onto the blade of the mounting bracket until it snaps into place.
6. Connect the battery negative cable.
7. Test the relay operation.
Rear
REM0VAL AND INSTALLATION
The rear high speed blower motor resistor is used only on models with the optional rear heater-A/C unit.
1. Disconnect and isolate the battery negative cable.
2. Remove the cover from the rear heater-A/C unit.
