RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Auto Shut Down (ASD) Relay: Description and Operation
AUTOMATIC SHUTDOWN (ASD) RELAY SENSE - PCM INPUT
The ASD relay is located in the Power Distribution Center (PDC). The PDC is located in the engine compartment. Refer to label on PDC cover
for relay location.
A 12 volt signal at this input indicates to the PCM that the ASD has been activated. The relay is used to connect the oxygen sensor heater element,
ignition coil and fuel injectors to 12 volt+ power supply.
This input is used only to sense that the ASD relay is energized. If the Powertrain Control Module (PCM) does not see 12 volts at this input when
the ASD should be activated, it will set a Diagnostic Trouble Code (DTC).
AUTO SHUTDOWN (ASD) RELAY - PCM OUTPUT
The 5-pin, 12-volt, Automatic Shutdown (ASD) relay is located in the Power Distribution Center (PDC). Refer to label on PDC cover for relay
location.
The ASD relay supplies battery voltage (12+ volts) to the fuel injectors and ignition coil(s). With certain emissions packages it also supplies
12-volts to the oxygen sensor heating elements.
The ground circuit for the coil within the ASD relay is controlled by the Powertrain Control Module (PCM). The PCM operates the ASD relay by
switching its ground circuit ON and OFF.
The ASD relay will be shut-down, meaning the 12-volt power supply to the ASD relay will be de-activated by the PCM if:
-
the ignition key is left in the ON position. This is if the engine has not been running for approximately 1.8 seconds.
-
there is a crankshaft position sensor signal to the PCM that is lower than pre-determined values.
The PCM will sense if or when the ASD relay has been activated through a "sense circuit". Refer to Automatic Shut-Down (ASD) Relay
Sense.PCM Input for additional information.
