RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Wiper Control Module: Description and Operation
An intermittent wipe module is used on vehicles that are not equipped with the optional Vehicle Theft Security System (VTSS). In addition to low and
high speed, the intermittent wipe system has a delay mode. Electronic circuitry within the intermittent wipe module is used to accomplish the wiper delay
mode. The delay time selected by the driver has a range of from about 1/2 second to about 18 seconds.
The driver selects the length of the delay by placing the wiper (multi-function) switch knob in one of five different intermittent wipe detent positions.
One of the detent positions sends a battery voltage signal to the intermittent wipe module, while the other four positions use resistors to provide
progressively lower voltage signals to the module. If the washer knob is depressed while the wiper switch is in the OFF position, the intermittent wipe
module will operate the wiper motor for approximately three wipes and automatically turn off the motor.
The intermittent wipe module is snap-fit onto a single blade-type mounting bracket located on the instrument panel reinforcement above the glove box
opening. The intermittent wipe module cannot be repaired and, if faulty or damaged, it must be replaced.
