RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Relay and Fuse Block Remove/Install
7. Disengage the relay and fuse block from the two mounting tabs on the inboard side of the left instrument panel end bracket.
8. Remove the relay and fuse block, the fuseblock module and the instrument panel wire harness from the instrument panel as a unit.
INSTALLATION
NOTE: If the relay and fuse block and the fuseblock module are being replaced with new units, be certain to transfer each of the fuses, circuit
breakers and relays in the faulty units that have not been included with the replacement units to the proper cavities of the replacement units.
1. Position the relay and fuse block, the fuseblock module and the instrument panel wire harness to the instrument panel as a unit.
2. Engage the relay and fuse block onto the two mounting tabs on the inboard side of the left instrument panel end bracket.
3. From the left outboard end of the instrument panel, install and tighten the two screws that secure the fuseblock module to the left instrument panel
end bracket. Tighten the screws to 3.4 Nm (30 in. lbs.).
4. Engage each of the retainers that secure the instrument panel wire harness to the instrument panel armature. Refer to Connector Locations for the
location of more information on the instrument panel wire harness retainer locations.
5. Install all of the fasteners that secure each of the instrument panel wire harness ground eyelets to the instrument panel armature.
6. Reconnect each of the instrument panel wire harness connectors.
7. Install the instrument panel assembly into the vehicle.
8. Reconnect the battery negative cable.
