RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke, or companion flange, for alignment reference.
3. Disconnect and remove propeller shaft.
Fig. 79
4. Remove old seal with Seal Remover C-3985-B (Fig. 79) from overdrive housing.
INSTALLATION
1. Place seal in position on overdrive housing.
Fig. 80
2. Drive seal into overdrive housing with Seal Installer C-3995-A (Fig. 80).
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to
rear axle pinion yoke
