RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Fig. 27
4. Install seal with Installer 8108 and Handle C-4171 (Fig. 27).
NOTE: Pinion depth shims are placed between the rear pinion bearing cone and pinion gear to achieve proper ring and pinion gear mesh. If the
factory installed ring and pinion gears are reused, the pinion depth shim should not require replacement or adjustment. Refer to Pinion Gear Depth
to select the proper thickness shim before installing rear pinion bearing cone.
5. Place the proper thickness pinion depth shim on the pinion gear.
Fig. 28
6. Install the rear bearing and oil slinger, if equipped, on the pinion gear with Installer C-3095-A (Fig. 28).
