RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Fig. 9
13. If the additional clamp causes an additional vibration, separate the clamps (1/4 inch above and below the mark). Repeat the vibration test (Fin. 9).
14. Increase distance between the clamp screws and repeat the test until the amount of vibration is at the lowest level. Bend the slack end of the clamps
so the screws will not loosen.
15. If the vibration remains unacceptable, apply the same steps to the front end of the propeller shaft.
16. Install the wheel and tires. Lower the vehicle.