RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
Wiper Control Module: Service and Repair
An intermittent wipe module is used on vehicles that are not equipped with the optional Vehicle Theft Security System (VTSS). See Intermittent Wipe
Module and Central Timer Module.
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS AND SEAT BELTS/AIRBAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL AND INSTALLATION
1. Disconnect and isolate the battery negative cable.
2. Roll down the glove box from the instrument panel.
Intermittent Wipe Module Remove/Install
3. Reach through and above the glove box opening to access the intermittent wipe module. Push the module towards the front of the vehicle to
disengage the snap-fit slot on the intermittent wipe module from the slide tab of the mounting bracket on the instrument panel armature.
4. Lower the intermittent wipe module into the instrument panel glove box opening far enough ti access and unplug the wire harness connector.
5. Reverse the removal procedures to install.
