RAM 2500 Van V8-5.2L VIN Y (1998)
15.
Position the front latch cover onto the inner door panel with the knob latch rod and the outside handle shaft inserted in the cover holes.
16.
Install the cover screws in the door panel.
17.
Position the inside door handle spacers and the inside handle onto the outside handle shaft. Verify both spacers are installed.
18.
Attach the inside handle with the screw.
19.
Install lock knob.
20.
Position the door trim panel on the door inner panel and press inward around the edge of the panel.
21.
Position the door pull handle onto the trim panel with the screw holes aligned.
22.
Install the pull handle screws.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE: P8- New Part
