RAM 2500 Van V8-5.2L VIN Y (1998)
HCU Brake Lines
11. Disconnect brake lines from Hydraulic Control Unit (HCU).
12. Remove the front mounting bolt through access opening.
13. Remove the rear mounting bolt from the engine compartment.
14. Tilt the assembly upward were the brake lines attach and remove the assembly from the mounting bracket.
INSTALLATION
1. Install the assembly into the mounting bracket.
2. Install mounting bolts and tighten to 15 Nm (11 ft. lbs.).
3. Install the brake lines to HCU and tighten to 13 Nm (115 inch lbs.).
4. Connect the CAB harness connectors and lock in place.
5. Install the reservoir in the engine compartment. Connect the pump motor connector and pump hose.
6. Install the washer reservoir mounting screws.
7. Install the battery and power distribution center mount.
8. Install the power distribution center.
9. Install the battery and battery cables.
10. Connect the horn connector and install the access cover.
11. Install the extension panel.
12. Install left turn signal housing.
13. Bleed the brake system.
