RAM 2500 Van V8-5.2L VIN Y (1998)
WARNING:
Wear a suitable pair of rubber gloves when removing the battery. Safety glasses should also be worn.
10.
Remove the three screws that secure the bottom of the battery tray to the battery tray support (Figure 5).
11.
Remove the two screws that secure the outboard side of the battery tray to the left cowl side panel (Figure 5).
12.
Lift the battery tray slightly and disconnect the battery temperature sensor electrical connector.
13.
Remove the battery tray and the drain tube from the vehicle as an assembly (Figure 5).
14.
In the area below the battery location, inspect the front (large) wiring harness connector on the ABS control module for acid damage, by spraying
the connector and surrounding area with the provided Electrolyte Detection and Neutralizing Spray (Figure 6).
>
If the spray remains an orange color, there is no electrolyte (battery acid) on the ABS control module wiring harness connector. Continue with
Section E - Battery Tray Installation.
