RAM 2500 Van V8-5.2L VIN Y (1998)
V-8 ENGINE
Intake Manifold Bolt Torque Sequence - (V-8)
^
Step 1-Tighten bolts 1 through 4, in sequence, to 8 Nm (72 inch lbs.) torque. Tighten in alternating steps 1.4 Nm (12 inch lbs.) torque at a
time.
^
Step 2-Tighten bolts 5 through 12, in sequence, to 8 Nm (72 inch lbs.) torque.
^
Step 3-Check that all bolts are tighten to 8 Nm (72 inch lbs.) torque.
^
Step 4-Tighten all bolts, in sequence, to 16 Nm (12 ft. lbs.) torque.
^
Step 5-Check that all bolts are tighten to 16 Nm (12 ft. lbs.) torque.
9. Connect the vacuum supply hoses to the intake manifold.
10. Connect the fuel injector harness to the injectors.
11. Connect the coolant temperature sending unit(s).
12. Connect the heater hoses and bypass hose.
13. Install the distributor assembly. Refer to Powertrain Management for the correct procedure.
14. Install and connect the oil pressure sending unit.
15. Connect the accelerator linkage and if so equipped, the speed control and transmission kickdown cables.
16. Install the fuel supply line.
17. Connect the MAP, TPS, and IAC connectors.
18. Install the generator and drive belt. Tighten generator mounting bolts to 41 Nm (30 ft. lbs.) torque.
19. Install the air cleaner.
20. Fill cooling system.
21. Connect the battery negative cable.
22. Start engine and check for leaks.
23. Install the engine cover.
