RAM 2500 Van V8-5.2L VIN Y (1998)
Engine Exhaust Manifold Installation - V-8
1. Position the engine exhaust manifolds on the two studs located on the cylinder head. Install conical washers and nuts on these studs.
2. Install two bolts and conical washers at the inner ends of the engine exhaust manifold outboard arms. Install two bolts WITHOUT washers on the
center arm of engine exhaust manifold. Starting at the center arm and working outward, tighten the bolts and nuts to 34 Nm (25 ft. lbs.) torque.
3. Install the exhaust heat shields. Tighten the screws to 6 Nm (55 inch lbs.) torque.
4. Install the engine cover.
5. Raise and support the vehicle.
6. Assemble exhaust pipe to manifold and secure with bolts, nuts and retainers. Tighten the bolts and nuts to 26 Nm (19 ft. lbs.) torque.
7. Lower the vehicle.
8. Connect the negative cable to the battery.
