RAM 2500 Van V8-5.2L VIN Y (1998)
Recirculation Air Door Remove/Install
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the actuator latch while pulling firmly outward on the actuator to remove the
actuator from the mount on the distribution duct.
5. Swing the actuator around the floor-panel door lever about 1800, or until the actuator link is at almost a right angle on the opposite side of the
lever, then disengage the hole on the end of the link from the pin on the end of the lever.
6. Remove the floor-panel door actuator from the distribution duct.
7. Reverse the removal procedures to install.